Metz MECABLITZ 52 AF-1 digital Pentax - Manual (Page 158)

158
9.2 Remote controller mode settings
In remote control mode the flash of the
master flash unit only assumes the control
function and does not contribute to exposure
of the shot!
9.2.1 Remote controller mode settings
• Switch on the flash unit with the ባ
button. The start screen appears.
• Press the sensor button of the displayed
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
• Press the sensor buttons on the
touch display and select .
• Press the sensor button on the
touch display.
Remote controller mode is set.
CONTROL
CONTROL
9.3 Remote slave flash mode
The flash unit supports the wireless Pentax
P TTL remote system.
At the same time, one or more slave flash
units can be remotely controlled from one
master flash unit on the camera (e.g. meca-
blitz 52AF-1P digital).
So that multiple remote systems in the same
room do not interfere with one another, there
are four independent remote channels avai-
lable (CH 1, 2, 3 or 4).
Master and slave flash units belonging to the
same remote system must be set to the same
remote channel.
The slave flash units must be able to receive
the light from the master flash unit with the
integrated sensors for the remote mode .
Depending on the camera model, the came-
ra’s internal flash unit can also function as
master flash unit. Please consult the respec-
tive camera operating instructions for further
tips on setting the master flash unit.
REMOTE
CONTROL
INFO
Z OOM 35 mm
MASTER
CONTROL
SLAVE
INFO
EV
0,7 -7,9 m
Z OOM 35 F4.0 m
m
P TTL
k