Metz MECABLITZ 52 AF-1 digital Pentax - Manual (Page 159)

159
9.3.1 Remote slave flash mode settings
• Switch on the flash unit with the
ባ
button. The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last (e.g. M flash mode).
• Press the displayed mode of operation on
the touch display as many times as it takes
for the display for selecting the mode of
operation to appear.
• Press the sensor buttons on the
touch display and select "SLAVE".
• Press the sensor button on the
touch display.
Remote slave mode is set.
In addition, the selected flash mode (e.g.
TTL) and the remote channel (e.g. CH 1) are
displayed.
SLAVE
9.3.2 Setting the slave channel
• Press the sensor button on the touch dis-
play for the channel group (e.g. ).
The window for selecting the channel and
group appears.
• Press the sensor buttons on the touch
display for the channel "CH".
• Press the sensor buttons on the
touch display and select the desired
channel.
• Press the selected channel on the touch
display.
The setting will take effect immediately.
9.3.3 Set slave mode
• Press the sensor button on the touch dis-
play for the partial light output/exposure
correction (e.g.
). The window for
the selection appears.
• Press the sensor buttons on the touch dis-
play for the channel "MODE".
• Press the sensor button on the touch dis-
play for the desired mode of operation
or .
The setting is applied automatically. TTL
M
TTL I CH1
TTL I CH1
INFO
EV
EV
0,7 -7,9 m
Z
OOM 35 F4.0 m
m
P TTL
MASTER
SLAVE
SERVO
REMOTE
SLAVE
INFO
Z
OOM 35 mm
TTL
CH
1 k
1
2 CH
3
1
CH
TTL
MODE
EV
REMOTE
SLAVE
INFO
Z OOM 35 mm
TTL
CH
1
1
CH
TTL
MODE
EV
REMOTE
SLAVE
INFO
Z OOM 35 mm
TTL
CH
1
M
TTL