Metz MECABLITZ 52 AF-1 digital Olympus - Manual (Page 154)

10.4.2 Pre-flash suppression or
synchronisation settings
• Set the camera to TTL mode.
• Press the sensor button on the
touch display as many times as it takes
for the display for selecting the type of
synchronisation.
• Press the sensor button on the touch
display:
synchronisation without pre-flash
synchronisation with pre-flash
The mode of operation is adopted
If the synchronisation set here does not work
properly, then proceed as described in
10.4.4.
SYNC
10.4.3 Servo mode partial light output
settings
• Press the sensor button for partial light
output on the touch display as many times
as it takes for the partial light output
display to appear.
• Press sensor buttons on the
touch display and set the desired partial
light output to 1/1, 1/2, 1/8 or 1/128.
• Press the sensor button on the touch
display for the selected partial light output
(e.g.
(z.B. 1/16).
The partial light output is adopted.
Once the slave flash units have achieved
flash-readiness, the AF measurement flash
flashes.
Slave groups and remote channels cannot be
set in SERVO mode.
The camera flash unit may not work in the
remote mode
P
1/16
154
k
INFO P
M-SERVO
Z OOM 24 mm
SYNC
SYNC
Learn
INFO P
M-SERVO
Z OOM 24 mm
SYNC
INFO 1/16
M-SERVO
Z
OOM 35 mm
SYNC
1/1
1/1 -1 /
3
1/8 -2 /
3
1/16
1/16 -1 /
3