Metz MECABLITZ 52 AF-1 digital Olympus - Manual (Page 136)

3.3 Switching the flash unit on and off
• Switch on the flash unit with the
ባ
button.
The start screen appears.
The flash unit always switches on
afterwards with the mode of operation that
was used last (e.g. manual flash mode M).
The ቨ button flashes red in stand-by
mode. To switch off the flash unit, press
the
ባ button until all displays turn off.
If the flash unit will not be used for an
extended period of time, we recommend that
you switch off the flash unit with the
ባ
button and remove the power source
(disposable/rechargeable batteries).
3.4 The selection menu
• Press the ቨ button as often as it takes
for the selection menu to appear.
The selection menu is divided into 4 sensor
buttons:
The modes of operation can be set after
pressing the
button.
TTL, see 7.1
TTL FP, see 7.4
M, see 7.3
M FP, see 7.4
SLAVE, see 10.2
SERVO, see 10.4
D
D
MODE
The flash parameters can be set after
pressing the
button.
EV (exposure correction), see 8
Zoom (reflector setting), see 9.1
F (aperture)
ISO (light sensitivity),
P (partial light output),
see 7.3 and 10.4.3
CHANNEL
3) (Channel), see 10.1.2, 10.2.2
GROUP 3) (slave group), see 10.2.3 .
3) only in SLAVE mode
The touch display can be configured after
pressing the
button, or the flash unit
can be reset to the factory setting.
CONTRAST see 14.1
BRIGHTNESS see 14.2
ROTATION (rotate the screen display),
see 14.3
RESET, see 15.3
PARA
SERVICE
+
52AF-1
OLY
136
k