Metz MECABLITZ 52 AF-1 digital Olympus - Manual (Page 144)

1/1 7,9m
1/1 -1 /
3
M
INFO 1/1
7,9 m
Z OOM 35 F4.0 m
m
7.3 Manual flash mode
In the manual flash mode M , the flash unit
emits the full uncontrolled amount of light if
no partial light output has been selected.
The specific photographic situation can be
taken into account by adjusting the aperture
setting or by selecting a suitable manual
partial light setting.
The setting area ranges from P 1/1 to
P 1/128 in
and mode. The display
shows the distance at which the subject is
correctly lit (see 5.2).
Setting the mode of operation
• Switch on the flash unit with the
ባ
button. The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last (e.g. TTL flash mode).
• Press the sensor button of the displayed
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
• Press the sensor buttons on the
touch display and select .
• Press the sensor button on the touch
display.
M M FP
M
M
• Set a suitable mode of operation on the
camera, e.g. M.
• Tap the shutter release to transfer data
between the flash unit and the camera.
Various cameras support manual flash mode
M only in the camera's M mode (manual).
In other camera models, an error message
appears in the display and the release is
locked.
Manual partial light output levels
Partial light output can be set in manual flash
mode .
Setting procedure
• Press the sensor button for partial light
output on the touch display as many times
as it takes for the partial light output
display to appear.
• Press sensor buttons on the
touch display and set the desired partial
light output to 1/1, 1/2, 1/8 or 1/128.
M
144
+
k
TTL
INFO
EV
0,7 -7,9 m
Z OOM 35 F4.0 m
m
TTL FP
M
M FP
M
INFO 1/1
7,9 m
Z
OOM 35 F4.0 m
m