Metro C200 Insulated Heated Cabinet - Manual (Page 2)

1
I. INTRODUCTION
A. IDENTIFYING YOUR CABINET
Your cabinet assembly has been shipped in two
cartons. The first carton contains the cabinet with
module. The other carton contains the slide racks.
There are three component numbers which you
may want to record for future reference: the cabinet
model number, the cabinet serial number and the
slide rack model number. Refer to the back of the
unit to locate the cabinet numbers. The slide rack
model number is located on the label affixed to the
ends of the rack carton. It is recommended that all
numbers be recorded in an appropriate place,
such as at the bottom of this page. AIso, please
record the cabinet model number and module
serial number on the Warranty Card found at the
back of this manual. Be sure to complete the
remainder of the Warranty Card and return it to
Metro within fifteen (15) days of delivery of the
cabinet. Once you have located and recorded
these numbers, refer to the sample numbers given
to identify the components of your C200 series
cabinet.
NOTE: Peel off any protective covering from
the exterior of the cabinet. Covering must be
removed before placing the cabinet into
service.
NOTE: Please read this manual thoroughly before using your
cabinet. If you should have questions, please contact
Metro customer service department.
TABLE OF CONTENTS
SECTION PAGE
I. Introduction
A. Identifying Your Cabinet ............................... 1
B. Features ....................................................... 2
II. Operating Instructions
A. Reversible Doors ......................................... 2
B. Slide Rack Assemblies ................................ 2
C. Holding Module ........................................... 3
III. Cleaning Instructions
A. Removal of Interior Components ................. 4
B. Specific Cleaning Instructions ..................... 4
C. General Cleaning Instructions ..................... 4
IV. Maintenance
A. Cabinet Maintenance ................................... 4
B. Module Maintenance ................................... 4
C. Blower Motor Maintenance .......................... 4
V. Repair Parts and Procedures
A. Cabinet ......................................................... 6
B. Module ......................................................... 8
Module Replacement Procedure Chart ........ 10
VI. Wiring Schematic
A. Holding ...................................................... 12
SAMPLE OF SLIDE RACK
CARTON LABELING
C4SC
SAMPLE OF CABINET LABELING
C200 PT S-D-LH
Cabinet Series
PT = Pass-Thru
(4 doors)
Blank = Non Pass-Thru
(2 doors)
Material S = Stainless Steel
N = Aluminum
Door Hinging
Blank = Right Hand
LH = Left Hand
Thermometer Type
Blank = Analog
D = Digital
Indicates Slide Racks
C4SC
= 2 Pair Wire —
3" Spacing
2C8SN = 2 Pair Aluminum
Fixed on 1 1 /
2
" Spacing
2CVSN = 2 Pair Aluminum
Adjustable
2C84 = 1 Pair Aluminum
Fixed on 1 1 /
2
" Spacing
1 Pair Wire — 3" Spacing
2CV4 = 1 Pair Aluminum
Adjustable
1 Pair Wire — 3" Spacing