Metro MetroMount Slimline (WMF-SL02) - Manual

INSTALLATION INSTRUCTIONS
MetroMount™ Slimline (WMF-SL02)
INSTALLATION WARNINGS:
Read the entire instruction sheet before you begin
installation or assembly. Installer must verify that the wall
will safely support the combined weight of all the attached
equipment and hardware. Improper installation of this
product can cause extensive property damage or serious
personal injury, either during or after the installation. It is the
responsibility of the installer to ensure that all applications
including wood, concrete, block, brick, steel, etc. are secured
properly to code. California installations could require
specific anchorage, and additional mounting screws. Check
with local authorities for codes in your area. Other seismic
states have similar regulations.
WARNING:
Max load 30 lbs of applied equipment including but not
limited to: LCD, keyboard, mouse, cabling and peripherals.
DISCLAIMER:
The Manufacturer and/or Distributor will bear no
responsibility for any damages of any kind arising from
any improper installation of this product. Because wall
construction varies widely and the ultimate method of
mounting is out of the Manufacturers or Distributors
control, it is imperative that the installer consult with local
engineering, architectural, or construction personal to
ensure the wall is constructed properly and to code to
handle the applied load.
InterMetro Industries Corporation
651 North Washington Street
Wilkes-Barre, PA 18705
www.metro.com
4.1 4.2
5.1 5.0
Slide the
monitor onto
the vesa plate
until the quick
connect snaps
into place
Affix the six (6)
velcro hook and
loops to the
keyboard tray
Position and
press the
keyboard onto
the tray
Monitor mount
allows for 90° vesa
rotation
Tighten or loosen
set screws on
both sides to
disable auto-
retract feature
Actuate lever
for height
adjustment
OOLS REQUIRED
TOOLS
REQUIRED
PARTS INCLUDED
Wall Mount Console Screw Pad Pan Head Screw Toggler
Mouse cable
manager
LO7-107