Technical specifications, Ce label, Pin assignment of the phoenix mcd connector – Meinberg HSC509 User Manual

Page 27

Technical Specifications

RECEIVER:

Direct conversion quadrature receiver with automatic gain control
Bandwidth: approx. 20Hz

DISPLAY:

LC-Display, 4 x 16 characters
Power (Netz), modulation (Mod.), field strength (Feld) and
running on XTAL (Freil.) indicated by LEDs

TIMECODE
CHECK:

multiple software check of the incoming timecode
parity and consistency check over a period of two minutes

RUNNING
ON XTAL:

without RF signal the clock runs on XTAL
with an accuracy of 10

-6

BUFFERING:

In case of supply voltage failure the on-board RTC keeps the
time based on XTAL and the content of the RAM for more than
100 hours (buffer capacitor)
optional lithium backup battery (life time: 10 years)

RELIABILITY
OF OPERATION: A software watchdog lets the microprocessor recover from

malfunction. A power-fail comparator resets the microproces-
sor if the supply voltage drops below a specified threshold.

SLAVE LINE
OUTPUTS:

bipolar slave clock pulses (minute and second), DC isolated,
short circuit proofed
pulse voltage: 24V
pulse current: 0.6A max.
pulse width:

1s (minute slave line)
0.5s (second slave line)

OUTPUTS:

4 relay outputs (changeover contact); max. 50W load each

This manual is related to the following products:

UA509P