Meinberg HSC509 - Manual (Page 15)

15
Select a Switching Program
The no. of the switching program to edit (01 ... 64) can be choosen by pressing INC
while the cursor appears at the corresponding position (PRG).
When pressing INC while CLR/ACK is already pressed the program no. is set back
to 01. After the switching program no. is selected the corresponding relay and the
switching times can be edited in the same way.
After this inputs have been done, it is important to save the switching program by
pressing CLR/ACK before the next switching program is selected. Otherwise the
edited modifikations are lost.
Because the calculation of the plans is based on greater/less compa-
rations of the switching times it is necessary to sort the switching
programs of one relay in a chronological order, but not all successive
switching programs have to be programmed.
ATTENTION