MEGAPOWER MVP-886 - Manual (Page 30)

- 26 -
13 Q&A
Question Answer
Check if the power supply cables are fine connected.
Make sure to turn on the Power.
Check if the audio cable or RGB cable is fine connected.
Check if the input/output connection is correct
Press SIGNAL button on the remote control to switch to VGA mode
No image,
No sound
Check if the camera cover has been taken off.
Make sure the distance between camera and object is over 330mm
The object maybe too shiny or with strong reflective surface. Please
adjust the surrounding brightness.
Image
unclear
The camera maybe too dirty, please clean it.
Fuzzy wave Try turning on the upper light.
Turn on the upper light to increase brightness. Image too
dark Or add Brightness
Control
panel
unworkable
Do not switch the buttons too speedily. Take a stop before press the
next button.
Clear the barrier between remote control and visualizer.
Keep the distance within 10m.
Remote
control
unworkable
Check if it is out of battery.
Check the cable if it is fine connected.
Check if microphone is workable
Microphone
soundless
Check the volume adjuster if it is right set.