MEGAPOWER MVP-886 - Manual (Page 19)

- 15 -
Note:
⑴
Monitor output and projector output are separately
independent.
⑵
In STAND-BY state, signal output default is PC VGA.
⑶ When it is outputting CVBS, only PC signal and Laptop signal
can be output.
6.6.4 【CVBS】
Under VGA output mode: Press the “OUTPUT” button on the
remote control to start VGA output, and then the monitor and
projector will output the PC signal.
Under CVBS output mode: Press the “OUTPUT” button on
the remote control to shut off VGA output, and then the monitor
and projector will output the visualizer signal.
Note: ① Setting of CVBS can be carried out through “MENU”.
② Default is in VGA output mode if system restarted.
③ Lap-top
VGA output
CVBS can be output through RCA
cable which is connected with
monitor such as TV.