Measurement Computing PCM-DAC02 - Manual (Page 6)

2 INSTALLATION
2.1 INSTALL InstaCal™ SOFTWARE
InstaCal is the installation, calibration and test software supplied with the board.
Refer to the Extended Software Installation Manual to install InstaCal.
2.2 INSTALL THE PCMCIA CARD
Your PCM card is completely plug and play. There are no switches or jumpers to set
prior to installation in your computer. Simply follow the steps shown below to install
your PCM hardware.
1. Insert the card into a free PC Card/PCMCIA type II or III slot. You do not
have to turn the computer off. The system is designed for power on
installation. Shown here is a PCM card case looking into the connector
which is inserted into the PCMCIA slot of your computer. The KEY helps to
insure that the PCM board is inserted in the correct orientation.
2. If the appropriate driver is already loaded on the PC, the card should be
detected, recognized, and configured by Windows and you should hear an
insertion beep. To verify the card has been recognized, go to Control
Panel\System\Device Manager and the card should now appear under "DAS
Component."
2