Measurement Computing Personal Daq rev.6.0 Quick Start - Manual (Page 8)

6 p/n 491-0940, Rev 6.0 878495 Personal Daq Quick Start
(4) Configure the System
This step pertains to the configuration of channels and acquisition parameters through Personal DaqView
software. To configure a set of parameters, use the appropriate toolbar button (or the View pull-down
menu) to open the applicable window. Clicking on the Configure Channel Settings button (9) brings up
the Channel Configuration Window.
Main Control Window
Channel Configuration Window, with Analog Input Spreadsheet Selected
Button Function
1 Open Configuration File Opens a selected configuration file.
2 Save Configuration File Saves the current configuration file to disk.
3 Select Active Device Provides a means of selecting active devices from the Personal Daq system.
4 Arm Trigger for Disk
Recording Arms the trigger and stores acquisition data to a designated disk file. If Auto Rearm is
selected, clicking this button puts Auto rearm in effect. This button, is also used to
disarm the data acquisition.
5 Manual Trigger Used to trigger the device when the mode of trigger is set to “Manual.” Note that the
Manual Trigger button can not be depressed until after the trigger is armed, for
example, by first pressing button 4.
6 Update Digital Outputs Updates digital outputs for all digital channels that are selected to “output state.” also
see Digital Input/Output Spreadsheet, in chapter 4 of the user’s manual.
Digital I/O does not apply to Personal Daq/54 .
7 Configure Data
Destination
Accesses the Configure Data Destination window. Note that this window provides a
means of selecting sequential destinations through an auto rearm feature.
8 Configure Acquisition Accesses the Configure Acquisition window.
9 Configure Channel
Settings
Brings up the Channel Configuration window. From this window you can configure
channels for Analog Input, Frequency/Pulse Input, and Digital Input/Output channels,
depending on which tab is selected.
10 Update All Indicators Starts all on-screen indicators with a display of up-to-date data. Has no affect on the
recording of data to disk. Auto Rearm, even if selected, will not occur when using this
control. This button is also used to pause all indicators.
11 Display Scrolling Charts Displays data graphically in a scrolling chart.
12 Display Bar Meters Displays data in a bar graph format.
13 Display Analog Meters Displays data displayed in a dial-gage format.
14 Display Digital Meters Displays data in a digital meter format.
15 View Data Launches an independent post-data acquisition program such as eZ-PostView, if
installed. The install CD includes a .pdf version of the eZ-PostView document.
16 Enable Readings
Column
Activates the Channel Configuration Window’s reading column. Does not affect the
recording of data to disk.
17 Disable Readings
Column
Stops the Channel Configuration Window’s reading column. Does not affect the
recording of data to disk.