Measurement Computing Personal Daq rev.6.0 Quick Start - Manual (Page 10)

8 p/n 491-0940, Rev 6.0 878495 Personal Daq Quick Start
The Configure Acquisition Window has the following default settings.
Pre-Trigger: No duration set, i.e., a duration of 0 scans
Trigger: Immediate
Post Trigger: Manual stop
Averaging: None
Acquisition Parameters:
Set for Maximum scan rate
Frequency: selected
Period: not-selected
Continuous Calibration: not-selected
Overrange Protection: selected
You can change the acquisition setup as desired. Explanations of setup options are discussed in chapter 4
of the user’s manual.
Functions that can be obtained with Main Control Window toolbar buttons can also be obtained through
pull-down menus (discussed subsequently). See chapter 4 of the manual for more detailed information.
(4c) Data Destination Configuration
The Data Destination window can be
accessed with the Configure Data
Destination button (7) [location shown
in the figure below].
From the Data Destination window you
can assign a filename and folder location
for the acquisition data. More detailed
information is provided in chapter 4 of
the user’s manual. Data Destination Window
(5) Collect Data
Click the Enable Readings Column button (16) [see page 1-8 for button location], or click the Update All
Indicators button (10) [see following figure for location] to start the acquisition. The data acquisition
begins and the readings column becomes active. However, data is not recorded to disk. Clicking the Arm
Trigger for Disk Recording button (4) will send the data to disk.
Click one of the toolbar’s display icon buttons (11, 12, 13, or 14) to see your data in the form of a chart or
meter. Display options are as follows: (11) is scrolling charts, (12) is bar graph meters, (13) is analog
meters, and (14) is digital meters. Note that you can view all display types, or a combination of them, at
the same time.
Note 1: For scrolling charts, a Chart Setup Wizard is used to set up the desired chart display. Channels
not set up in the display can still be enabled and read on the channel configuration window.
Note 2: Chapter 4 is devoted entirely to the Personal DaqView program and its Chart Setup Wizard
feature.