Measurement Computing Personal Daq rev.6.0 Quick Start - Manual (Page 3)

Personal Daq Quick Start 878495 p/n 491-0940, Rev. 6.0 1
Personal Daq
Quick Start
For: Personal Daq/54, /55, /56
PDQ1 and PDQ2
When using Personal Daq modules to acquire data, computer energy save modes can cause
false data readings. Prior to using Personal Daq modules, ensure your computer’s energy save
mode is disabled. If needed, consult your PC user’s manual to disable energy save (power
suspension) modes.
(1) Install Software
IMPORTANT: Software must be installed before installing hardware.
If you purchased software, e.g., Personal DaqViewXL, an associated authorization code was
included with your order. If this is the case keep your code in a safe place. You will need
to enter it prior to the initial run of that application.
For successful operation, your computer should conform to the following, as a minimum:
• PC system with Pentium® processor
• Available USB port
• Microsoft Windows 98SE (Second Edition), WindowsMe/2000 or /XP
• 16 Mbytes of RAM (32 Mbytes, or greater, is recommended)
• Energy Save modes disabled (see note at top of page)
After reviewing the previous notes and ensuring that your computer meets or exceeds the minimum
requirements, perform the installation according to the following steps:
1. Remove previous version Daq drivers, if present. You can do this through Microsoft’s
Add/Remove Programs utility located in the Windows Control panel. Navigation to the
utility from the Windows Desktop is as follows:
Start ® Settings ® Control Panel ® Add/Remove Programs
2. Place the Data Acquisition CD into the CD-ROM drive. Wait for PC to auto-run the CD.
This may take a few moments, depending on your PC. If the CD does not auto-run, use the
Desktop’s Start/Run/Browse feature to access and run the .exe file from the drive.
3. After the intro-screen appears, follow the screen prompts.