Measurement Computing GPIB-488.2 - Manual (Page 62)

3-44 IOtech to Associated MCC APIs
986992 GPIB 488.2 Porting Guide
IOtech GPIB Command Associated MCC GPIB 488.2 Command
TriggerList TriggerList
Syntax
TriggerList {
IOtech
} INT WINAPI TriggerList(DevHandlePT
devHandleList);
TriggerList {
MCC
} void TriggerList(int board, int addresslist[])
Usage Notes
TriggerList {
IOtech
} – IOtech’s TriggerList command issued a Group Execute Trigger
(GET) bus command to the specified devices. If no interface devices were specified, then the
GET only affected devices that were already in the Listen state, as a result of a previous
Output or Send command.
TriggerList {
MCC
} – Used to trigger multiple devices. Use Trigger to trigger only one
device.
The following example shows how we would trigger two devices simultaneously. The example
devices are connected to board 0; and are at GPIB addresses 6 and 7.
Example:
short addresslist[3] = {6, 7, NOADDR};
TriggerList(0, addresslist);