Measurement Computing GPIB-488.2 - Manual (Page 48)

3-30 IOtech to Associated MCC APIs
986992 GPIB 488.2 Porting Guide
IOtech GPIB Command Associated MCC GPIB 488.2 Command(s)
PPollDisable PPollUnconfig
Syntax
PPollDisable {
IOtech
} INT WINAPI PPollDisable(DevHandleT
devHandle);
PPollUnconfig {
MCC
} PPollUnconfig(int board, short addresslist[]
Usage Notes
IOtech’s PPollDisable command, to no longer be used, disabled the Parallel Poll response
of a selected bus device.
MCC’s PPollUnconfig command is used to unconfigure devices for parallel polls.
In the following example, the command unconfigures all devices connected to board 0, which
are located at GPIB addresses 6 and7.
Example:
short addresslist[3] = {6, 7, NOADDR};
PPollUnconfig(0, addresslist);