Measurement Computing PC104-DAS08 - Manual (Page 5)

1 INSTALLATION
1.1 SOFTWARE INSTALLATION
Before you open your computer and install the board, install and run InstaCal, the
installation, calibration and test utility included with your board. InstaCal will guide
you through switch and jumper settings for your board. Detailed information
regarding these settings can be found below. Refer to the Software Installation
Manual for InstaCal installation instructions.
1.2 HARDWARE INSTALLATION
The PC104-DAS08 has three sets of switches / jumpers that should be set before
installing the board in the PC. There is a bank of DIP switches for setting the base
address, a jumper for setting the interrupt level and a bank of switches for setting the
analog input range. See Figure 1-1 below.
Figure 1-1. Switch and Jumper Locations
1
R A N G E S E L E C T
S W IT C H E S (S 2 )
IN T E R R U P T LE V E L
S E LE C T J U M P E R S
X (N O IR Q ) S H O W N
A D D R E S S S E L E C T
S W IT C H E S
D e fa ult 30 0h s h ow n
P IN 1
(U N D E R )