Measurement Computing DASYLab Getting Started - Manual (Page 9)

Exercise: Acquiring, displaying, and writing analog data
9
3. Double-click on the Analog Input module to open its module dialog
box.
By default, analog channel 0 is enabled. You can enable other channels
by clicking on them.
For this exercise, leave channel 0 enabled and all other channels
disabled.
4. Enter –5.000 in the Lower limit box and 5.000 in the Upper limit
box.
5. Click Measurement to open the Measurement Setup dialog box.
6. Click Modify to open the Modify Timebase dialog box.
7. Change the Scan rate to a rate supported by your device.
Note: If you are using the DEMO-BOARD, select 100 for the scan rate,
which is the maximum for that device.
8. Click OK on the Modify Timebase , Measurement Setup , and
Analog Input dialog boxes to close all three dialog boxes, save your
settings, and return to the DASYLab worksheet.