Measurement Computing DASYLab Getting Started - Manual (Page 6)

Run InstaCal and add your MCC device
6
Run InstaCal and add your MCC device
To run InstaCal and add an MCC device to the InstaCal configuration,
complete the following steps.
1. Run InstaCal from the Start menu.
2. To add a USB, PCI/PCIe, or WLS device, click OK on the Plug and
Play Board Detection dialog box to add the device to the InstaCal
configuration.
To add any other type of device, complete the following steps:
a. Select Install»Add Board .
b. Click on the tab in the Board Selection List dialog box that
corresponds to the type of device you are using.
c. Select the device from the list, and click Add .
The device is added to the InstaCal configuration.
3. Select File»Exit to close InstaCal.
Install DASYLab
To install DASYLab from the installation CD, complete the following
steps:
1. Insert the CD in your CD drive.
The installation program should start automatically. If it does not,
browse the CD and double-click StartCD.exe .
Note: To download and install DASYLab, click the Download DASYLab
V13 link on the Software/Drivers Downloads page at
www.mccdaq.com/software.aspx to save the installation
program.
Save and then run the file, and click OK on the first dialog to
extract the installation files to the default location. By default, the
installation program runs automatically.
2. Exit all running programs and click Next .