MEGA Corp. MCC-OPS-1 - Manual (Page 18)

MCC35-CAT735-1
5 Aug 2010
SECTION 3
Normal Operations
Contents
3-1
Description …………..…………………… 3-1
Before Operations …..………………….... 3-1 Operations ………..……………………… 3-2
After Operations ………………………… 3-4
DESCRIPTION
This section provides normal bed operation
procedures for the MCC 35 on the CAT 735
LWB chassis only. These procedures are in
addition to and do not replace existing CAT
735 requirements. Refer to the CAT 735
Operations and Maintenance manual for other
specific CAT 735 operation instructions,
warnings and hazards. The MCC35 specific
operating procedures are also found in checklist
form located in the appendix and designed to
be used in the cab.
BEFORE OPERATIONS
These procedures are used to perform a walk-
around inspection of the MCC35 system before
use or the beginning of a shift. This inspection
requirement is in addition to and does not
replace the vehicle manufacture’s inspections.
Ensure all safety information, warnings and
instructions are read and understood before any
operation or maintenance procedures are
performed. Ensure proper safety procedures
are used when operations the MCC35. Failure
to use proper safety procedures and equipment
may cause serious personnel injury or death.
Power OFF
1. Chocks – Set As Required
2. Vehicle Parking Brake – ON
3. Gear Selector Lever – N (Neutral)
4. In Cab Controls – Set As Required
5. Cab Mounted Indicator Beacons –
Security and Damage
6. MCC35 Accumulator – Security
Damage and Leaks
7. LT Body Lift Cylinder – Security,
Damage, Leaks and Lubrication
8. LT Side Body Assembly, Centering
Guides, Twistlocks, Lights, Fender and
Mud Flap – Security, Damage and
Lubrication.
9. LT Pivot Pin – Security, Damage and
Lubrication
10. Body Position Sensor – Security and
Damage
11. Remote Bed Operation Switches –
Condition, Security and Damage.
12. Tailgate Assembly – Security, Damage,
Leaks and Lubrication.
13. Twistlock Mechanisms – Security,
Damage, Operation and Lubrication.
14. Tail Light and Accessories – Security
and Damage
15. Hydraulic Sequencing and Twistlock
Manifolds – Security, Damage and
Leaks.
16. RT Pivot Pins – Security, Damage and
Lubrication
17. RT Side Body Assembly, Centering
Guides, Twistlocks, Lights, Fender and
Mud Flap – Security, Damage and
Lubrication.