Marantz ST7001N - Manual (Page 8)

4
ENGLISH
FRONT PANEL
q Power ON/STANDBY switch
This is used to turn the unit’s power ON and STANDBY.
When it is pressed, the display lights and the power is
turned on; when it is pressed again, the power is turned
off and STANDBY indicator will be illuminated.
w STANDBY indicator
This indicator illuminates red when the unit’s status is
standby.
e Remote control sensor
This sensor receives the infrared light transmitted from
the wireless remote control unit.
For remote control, point the wireless remote control unit
to the sensor.
Some of the functions can be operated with the remote
control unit (RC7001ST).
r DIMMER button
The display’s brightness switches (in three levels) each
time this button is pressed.
t DISPLAY button
This button is used to select the display mode (
☞
page
12, 16, 23).
y Display
u MENU button
This button to ENTER/EXIT menu mode.
The unit times out if no operation is performed for about
5 seconds after the menu mode is set.
i AUTO TUNE button
Press to active auto location of all available DAB
services.
Press once for UK service or hold for longer than 2
seconds to activate an inter national search.
o SECONDARY indicator
This indicator illuminates when a secondary service is
available (
☞
page 19).
!0 BAND SELECT button
This button is used to select DAB, FM or AM.
!1 TUNED indicator
This indicator illuminates when a station is properly
tuned in.
!2 RDS indicator
This indicator illuminates when receiving RDS broadcasts,
and flashes during the RDS search.
!3 STEREO indicator
This indicator illuminates when an FM station is being
tuned into stereo condition.
!4 TUNING/PRESET knob
This knob is used in conjunction with the MENU button,
and is used to select and determine the operation mode.
Also, this knob is used for the TUNING/PRESET search.
In the tuning mode, the reception frequency is tuned up
or down. Turning the control in the clockwise direction
tunes the frequency up. Tuning the control in the
counterclockwise direction tunes the reception frequency
down.
In the preset mode, the selection of the preset channel is
moved up or down. The auto tuning operation cannot be
used when in this mode.
When entering station names, use this control to select
the letters (
☞
page 17).
Memo
• Whenever the Power ON/STANDBY switch is in the
STANDBY position, the unit is still connected on AC line
voltage.
Please be sure to unplug the cord when you leave home
for, say, a vacation.
• Noise may be generated if a near-by television set is on
during AM, FM or DAB broadcasting reception. The tuner
should be used as far away from a television as possible.
• Effective period of memory back-up is about a month
under normal temperature.
PART NAMES AND FUNCTIONS
PUSH ENTER PUSH ENTER
TUNING/PRESET TUNING/PRESET
STEREO STEREO RDS RDS TUNED TUNED SECONDARY SECONDARY
BAND SELECT BAND SELECT AUTO TUNE AUTO TUNE MENU MENU DISPLAY DISPLAY DIMMER DIMMER
STANDBY STANDBY
ON/STANDBY ON/STANDBY POWER POWER
DAB/FM/AM TUNER ST7001 DAB/FM/AM TUNER ST7001
q r t u i !0 !2 !4
!3 y e o !1
w
For details on the functions of these parts, refer to the pages given in parenthesis.
ST7001N 01 Eng 05.7.21 5:23 PM ページ4