7 remote control code setting, Part names and functions, 3 . x – Marantz ST7001N User Manual
Page 11: English
7
ENGLISH
7 Remote control code setting
The remote control unit contains 3 sets of remote control
codes, and it can be used to control up to 3 tuners in one
location. To control a second or third tuner, select the
remote control code as explained below. The selected tuner
can be operated from the remote control.
• When the unit is shipped from the factory, the main unit
and remote control are set to TUNER1.
1.
TUNER2
To set the remote control to TUNER2, hold down both
the
SHIFT
button
⁄3
and
2
number button
x
on the
remote control for at least five seconds.
TUNER3
To set the remote control to TUNER3, hold down both
the
SHIFT
button
⁄3
and
3
number button
x
on the
remote control for at least five seconds.
2.
Also set the main unit's remote control setting to the
same setting as the remote control.
3.
To change main unit's remote control setting, hold down
both the
SHIFT ⁄3
and
DISPLAY .
buttons on the
remote control; the remote control setting (“TUNER1”,
“TUNER2” or “TUNER3”) will be displayed in the display
window on the main unit and main unit setting will be
changed same setting as remote control.
Note
• To set the remote control back to TUNER1, hold down
both the
SHIFT
button
⁄3
and
1
number button
x
on the
remote control for at least five seconds.
• If the batteries in the remote control are replaced while the
remote control is set to TUNER2 or TUNER3, the setting
will revert to TUNER1.
• If the main unit is unplugged the mains cord, the remote
control setting will revert to TUNER1.
PART NAMES AND FUNCTIONS
REMOTE CONTROLLER
RC7001ST
SHIFT
R
E
EN
T
BAND
MENU
TUNING
CONTROL
CHANNEL/
A/B
C/D
E/F
TIMER
10
DISPLAY
DIMMER
9
8
7
4
5
6
3
2
T-MODE
I/J
G/H
SLEEP
MEMO
ON
STANDBY
1
/A-TUNE
A-PRESET
⁄3
.
x
ST7001N 01 Eng 05.7.21 5:23 PM ページ7