Marantz SR6005 - Manual (Page 44)

40
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Set up speakers
8
G When “Surround Back” is selected
in step 6H
Use o p to select the item.
Measure
(2spkrs)
Set for measuring two surround back
speakers.
Measure
(1spkr)
Set for measuring a surround back
speaker.
Skip Set for no measuring of a surround
back speaker.
9
G When “Front Height” is selected in
step 6H
Use o p to select the item.
Measure Set to measure the front height
speakers.
Skip Set when you do not want to measure
the front height speakers.
10
Press RETURN .
Proceed to page 9 STEP1 Preparation
step 5.
NOTE
After performing Audyssey® Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
Connections (Advanced connection)
REMOTE CONTROL jacks
When you use this unit connected to Marantz audio components, it sends operation signals to operate each component.
n Connection
Use the remote connection cable (supplied with a Marantz audio component you want to connect) to connect the REMOTE CONTROL OUT
terminal of this unit to the REMOTE CONTROL IN terminal of the component to be connected.
n Setting
Set the remote control switch located on the rear panel of the connected audio component to “EXTERNAL” or “EXT.” to use this feature.
• This setting will disable remote sensor reception of the connected audio component.
• To operate the connected audio component, point the remote control at the remote sensor of this unit.
EXTERNAL INTERNAL EXTERNAL INTERNAL EXTERNAL INTERNAL
REMOTE
CONTROL
OUT IN
REMOTE
CONTROL
OUT IN
REMOTE
CONTROL
OUT IN
CD recorder CD player DVD player
Remote control unit
Wireless receiver RX101 (vpage 22)
NOTE
To use wireless receiver RX101 as external
IR receiver, set the remote sensor function
of this unit to “Remote Lock:ON” (vpage 68
“Remote control settings”).