Sleep timer function – Marantz NR1604 User Manual
Page 99
96
HDMI control function
If the HDMI control function does not operate properly, check the
following points.
• Is the TV or player compatible with the HDMI control function?
• Is “HDMI Control” (
) set to “On”?
• Are the HDMI control function settings of all devices correct?
NOTE
• When “HDMI Control” is set to “On”, it consumes more standby
power.
• The HDMI control function controls operations of a TV that is
compatible with the HDMI control function. Make sure that the TV
and HDMI are connected when you perform HDMI control.
• Some functions may not operate depending on the connected TV
or player. Check the owner’s manual of each device for details
beforehand.
• When “Power Off Control” on the menu is set to “Off”
(
), this unit is not set to standby even if the connected
device is in the standby mode.
• When connection changes are implemented, such as adding
connections to HDMI devices, linked operations may be initialized.
In this case, you will need to reconfigure the settings.
• When “HDMI Control” is set to “On”, it is not possible to assign an
HDMI connector to “TV AUDIO” at “Input Assign” (
• Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat steps 2 and 3.
) setting has changed.
• There is a change to the connection between the devices and the
HDMI, or an increase in devices.
Sleep timer function
• You can have the power automatically switched to standby once a
set time has elapsed. This is convenient for viewing and listening
while going to sleep.
• The sleep timer function can be set for each zone (
“Sleep timer function”). (The MAIN ZONE setting method is
explained here.)
1
Press
MAIN
to switch the zone
mode.
MAIN
lights.
2
Press
SLEEP
and display the time you want to set.
The
SLEEP
indicator on the display lights.
• The time switches as shown below each time
SLEEP
is pressed.
Off
10 min
20
30
40
50
60
80
70
90
100
110
120
To confirm the countdown time before putting the
unit to sleep
Press
SLEEP
.
“Sleep : zmin” appears on the display.
z Countdown time
To cancel the sleep timer
Press
SLEEP
to set “Off”.
The
SLEEP
indicator on the display turns off.
• The sleep timer setting is canceled if this unit’s power is set to
standby.
• The sleep timer function can be set separately for the different zones
NOTE
The sleep timer function cannot turn off the power of devices
connected to this unit. To turn off the power of those connected
devices, set up sleep timers on the connected devices themselves.
Basic instructions
Advanced instructions
Information
Advanced instructions
DVD