Trigger out, Auto standby, Front display – Marantz NR1604 User Manual
Page 136
133
Trigger Out
Selects when to activate trigger out.
For details about how to connect the DC OUT jacks, see “DC OUT jack” (
Setting details
n When setting for zone (MAIN ZONE / ZONE2)
Trigger out is activated through linkage to the power of the zone set to “On”.
n When setting for input source
Activate trigger out when the input source set to “On” is selected.
Active for the zone set to “On” with “When setting for zone”.
• On : Activate trigger on this mode.
• – – – : Do not activate trigger on this mode.
Auto Standby
Default settings are underlined.
When you do not perform any operation on this unit with no audio or video input for a specified time,
this unit automatically enters the standby mode. Before it enters the standby mode, “Auto Standby” is
displayed on the display of this unit and the menu screen.
Setting details
60 min : The unit goes into standby after 60 minutes.
30 min : The unit goes into standby after 30 minutes.
Off : The unit does not go into standby automatically.
Front Display
Default settings are underlined.
Adjust the display brightness of this unit.
Setting items
Setting details
Display
On : Display is always on.
Auto Off : Display is off except when showing the status display.
Off : Display is always off.
Buttons on the main unit can be used for operations.
Each time
DISPLAY
is pressed, the setting is changed as shown
below.
On
Auto Off
Off
NOTE
When “Display” is set to “Off”, the display turns off and appears as if
there is no electricity.
General
Basic instructions
Advanced instructions
Information
Advanced instructions
DVD