MacroSystem Slivers - Manual (Page 9)

9 Slivers for Bogart SE User manual
You should now click on the Anchorpoint button and select
“Anchor scene bottom, center“. The active scene in the middle
part will now align itself in the middle and flush with the bottom
edge of the part.
You should now move the trackball pointer to the middle part.
The pointer changes into a hand symbol.
Activate the scene by clicking. This will enable you to move the
scene and to position it as you wish. You should then save the
position by clicking again.
You should now click on the Size slider in the Bars panel and
set the thickness of the dividing lines by moving the slider.
Confirm your selection by clicking.
Now, click on the color box in the Bars menu and select the
Solid menu option by clicking on the black color button.
Confirm your selection with OK.
The other parts can now also be filled with scenes that may be
positioned as you desire, by following similar procedures as for
the middle part.