MacroSystem Smart Edit 7 Release Notes - Manual

CASABLANCA Smart Edit 7
7.0 Release Notes
Known issues of 7.0:
DVDs created from HDV Edited Material Exhibits Line of distortion at bottom of the screen in
Underscan (this distortion line is not seen in HDV Tape Export).
New Photo Mode in the Record Menu does not function in an HDV Project.
No sound in the Audio Record/Edit menu with input set for DV.
This happens when you create a group name and add some scenes into that group, and then use the
Group Selection button from the “Opt” menu to choose that group and “delete” it. In the scene bin, the
scenes still part of that group will have the group name still with them. Dual monitor display shows the
names of the group names still under the scenes in the bin. Single video monitor mode would show that
scene is still part of that group under the “i” button. You have to manually clear this name out (choosing
the “---” name in the list) to have that group assignment blank again.
The group name appears to delete, however the “OK” button suddenly grays out. So you are unable to hit
OK to exit the menu and make this delete selection happen.
When playing a clip back with the time code setting turned on in Video, the counter will skip.
Time code is not available during Trimming or Splitting.
Different DV cameras, cables, or modes on the Casablanca make no difference. You can see the db levels
move up and down, but there is no sound through the speakers. However, the audio does capture and
plays properly on playback.
During Single VGA Monitor Mode there is no video signal visible when using
analog input for video recordings.
Single VGA mode still has audio sync drift on the playback of scenes.
If you experience this issue and do not have another monitor option - we recommend selecting the 800 x
600 60Hz setting where the audio sync drift is not an issue.
VGA Issues
In HDV projects:
In regular DV projects:
Additional Notes
The Delete Group option does not delete the group names attached to scenes.
Cannot Delete the last group name or all groups from the group list.
Time code display appears to jump during playback.