MacroSystem Columbus - Manual (Page 27)

26 27
head.
Next, open the “Timing” menu, set the “Route”
slider control to 4 seconds and view the “Pre-
view”. Afterwards, open the “Global settings”
menu by first setting the top selection button to
“Line type” in order to make changes, if neces-
sary, to the line (e.g. type, width, color).
Now open the “Look” menu and activate the
starting point (which you can still recognize by
its flag). Set the top selection button to “Object”
and set the “Object” button to “Off”. Proceed
in the same way with the finishing point so that
neither of the two points has an object (flag)
displayed.
Now open the “Global settings” menu and set
the top button to “Head object”. Then activate
the “Show head object” button so that a little
check mark appears and causes the remaining
buttons in this menu to become activated. Next,
click on the “Select head object” button and
select the “Right hand” from the 3D objects.
After confirming with “Ok”, you can make the
system calculate your scene - and that‘s it!