Lynx Studio LS-ADAT - Manual (Page 6)

LS-ADAT
Page 5
LS-ADAT Internal Card Installation
1. With your computer powered down, install the LS-ADAT in a bracket slot adjacent to the
LynxTWO/L22 as shown in the figure below. The LS-ADAT must be secured to the
computer chassis with a screw.
2. Connect the included 14-pin ribbon cable from connector JP1 on the LynxTWO/L22 to
connector JP2 on the LS-ADAT (labeled INT LSTREAM). The connectors on the ribbon
cable have polarizing tabs that insert into slots in the mating connectors. Insure that these tabs
are aligned correctly. Failure to do so may result in serious damage to the LynxTWO/L22
and LS-ADAT.
LynxTWO and LS-ADAT Installation in Computer Chassis