Lynx Studio LS-ADAT - Manual (Page 11)

LS-ADAT
Page 10
LS-ADAT Input Routing
As shown below, the ADAT data from the LS-ADAT is routed into the digital mixer of the host card
via the LStream 2 Header port. This data can be routed to the record bus using the Input Source
Select function within each Input Submixer.
Input 7/8
Input 5 / 6
Input 3 / 4
Input 1 / 2
Format
Pro/Con
Input 1 - 40
AES-3
RECV
ADC
Trim
+4 / -10
L
R
Analog In 1
Analog In 2
ADC
Trim
+4 / -10
L
R
Analog In 3
Analog In 4
Digital In L/R
LStream 1
Bracket Port
Input
LStream 2
Header Port
Input
Input 9-24 LStream 1
Receiver
Input 25-40
From output
loopback registers
Dual Internal
LStream 2
Receiver
Input Submixer 1 - 16
Input
Select
Mute Dither
Peak
Level
Digital Mixer Inputs
LStream
Out Port
Data Routing
&
S/MUX
ADAT
RECV
ADAT
RECV
ADAT Channels 1 - 8
Optical In 1
Optical In 2
ADAT Channels 9 - 16
LS-ADAT Input Section
LStream Channels 1 - 16
(Serial data on ribbon cable)
LynxTWO A Model Input Section
Record Bus
(16 Channels)
SRC
The Input Source Selection buttons on the Record/Play page of the LynxTWO/L22 Mixer provide
access to the input select function. These buttons are located just above the meters for each input
channel.
When these buttons are clicked, a menu containing the 40 possible input sources will be displayed.
To access channels from the internal version of the LS-ADAT, choose sources from LStream 2 In 1
through LStream 2 In 16.
Each Input Source is routed to either the left or right channel of a record device. The record device
number is located under the meters, e.g., Record 1, Record 2. When setting up for recording in an
audio editing application, these devices numbers are used to specify the recording source.