Lynx Studio LS-ADAT - Manual (Page 15)

LS-ADAT
Page 14
Specifications
ADAT O PTICAL I/O
Number / Type Two inputs and two outputs, compatible with Alesis ADAT Type I and Type II
Optical Digital Interface Protocol, up to 24-bit data
Channels 16 @ 44.1kHz 48 kHz sample rates
8 @ 88.2 kHz and 96 kHz sample rates, S/MUX enabled
4 @ 176.4 kHz and 192 kHz sample rates, SMUX enabled
Input Receiver Fast-locking phase-locked loop with 30 kHz to 55 kHz lock range
ADAT S YNCHRONIZATION I/O
Number / Type One 9-pin Sync In port compatible with Alesis Synchronization Protocol
Signals Time code (sample count), word clock, and MIDI control data
Sample Accurate
Methods
ASIO Positioning Protocol and hardware-based SMPTE frame address matching
logic (Cue Point).
MTC Time code to MTC conversion
MIDI MIDI port transfers serial input control data
C LOCK S YNCHRONIZATION
Clock Sources Host card (LynxTWO or L22), Optical In 1, Optical In 2, ADAT Sync In
Modes Master mode: utilizes LynxTWO or L22 low-jitter sample clock to drive external
ADAT devices
Slave mode: word clock derived from external ADAT device
A RCHITECTURE
Core FPGA-based core. Support for field upgrades of firmware.
Audio Devices Host Card is visible to applications as eight stereo record devices corresponding to
ADAT optical inputs 1 – 16 and eight stereo play devices corresponding to ADAT
optical outputs 1 – 16.
Routing/Mixing Integrates with host card’s digital mixer to allow independent routing of ADAT I/O
with host card analog and digital I/O.
C ONNECTIONS
I/O Ports (4) Bracket-mounted TOSLINK connectors. (1) 9-pin female D-sub connector.
Other LStream interface headers
G ENERAL
Host Interface Lynx proprietary LStream
™ Interface: 24.5 Mbps bi-directional
Requirements One available bracket position (PCI slot not required), Host card: LynxTWO or L22
Size 3.0” H X 5.0” W X 0.75” D
EMI Certifications FCC and CE
Shipping Weight 2 pounds