Lynx Studio LS-ADAT - Manual (Page 10)

LS-ADAT
Page 9
LStream Output Channel Group Mapping
The mapping of the digital mixer’s output channels to LStream channels can be controlled to
accommodate specific I/O configuration requirements. The Output Select control (labeled “1-8/9-16
Select” in the diagram above) allows the destination of the upper eight and lower eight mixer output
channels to be altered. This feature is particularly useful for re-routing output channels 1 – 8, which
are hardwired to the host card’s analog and digital outputs and to the LStream ports.
The Output Select control on the LStream page of the LynxTWO/L22 Mixer has two settings:
9-16/1-8 Maps mixer output channels 9-16 to LStream output channels 1-8 AND maps mixer output
channels 1-8 to LStream output channels 9-16 (this is the default setting).
1-8/9-16 Maps mixer output channels 1-8 to LStream output channels 1-8 AND maps mixer output
channels 9-16 to LStream output channels 9-16.
Typically, the default setting is easiest to work with if you are using only the first eight channels of
the LS-ADAT. If you are using all 16 channels of the LS-ADAT at 48 kHz it may be easier to use the
1-8/9-16 option. In this case, the numbering of the output channels of the LynxTWO/L22 mixer
corresponds to the LS-ADAT output channel numbering.
Please note that this section pertains to the mapping of LStream channels, and not to LS-ADAT
output channels. As will be discussed in a later section there is not always a one-to-one
correspondence between LStream channels and LS-ADAT I/O channels.