LSC Lighting NEXUS - Manual (Page 37)

NEXUS NexLan Software
Operator Manual V2.0
© 2011 LSC Lighting Systems (Aust) Pty. Ltd Page 31
The Control window for fixtures has five tabs: “Basic”, “Colour”, “Beam”, “Extra” and “Test”.
Each tab has slider controls for each of the channels in its group. Each channel has a
[Default] button to set the channel back to its default settings. When a parameter has
been varied, the [Default] button becomes a [Release] button.
The “Basic” tab also has Control and Macro functions.
The four “Control” buttons are:
 Release - release the fixture back to the network.
 On - set the fixture to a default “on” state (intensity full, shutter open and pan/tilt to
50%).
 Grab – Grab the current values from the network.
 Lock - remove the fixture from the show (intensity 0%, shutter close and pan/tilt to
50%).
The Macro area can be used to run macros like lamp on / lamp off or reset by selecting
them from the drop down box and clicking [Run]. When running a macro onto multiple
fixtures, each macro will be time delayed to prevent a power surge.
The “Test” tab can be used to test each parameter of a fixture by cycling it continuously
from minimum to maximum and back. Select a parameter to test from the drop down box
and click [Run]. To stop the test click [Release]