Leprecon LP-X24 Manual v3.2 Addendum - Manual (Page 52)

LP-X24 and LP-X48 Users Manual—Addendum
Chapter Five:
Advanced Programming and Editing
Techniques
Programming Virtual Channels
The LP-X24 has twenty-four manual faders twelve in Bank 1 and twelve in Bank 2.
The LP-X48 has forty-eight manual faders—twenty-four in Bank 1 and twenty-four in
Bank2.
In certain cases it will be desirable to have extra control channels. The LP-X24 has
seventy-two "virtual" channels
that is, channels that exist in the board's software but do
not have corresponding faders. The LP-X48 has 144 "virtual" channels.
You can see and program these channels only in the display section of the LP-X.
To Program Virtual Channels
1. Start by ensuring that all buttons and faders are in the proper positions.
Button/Fader Setting
Modes Record and Scene
Display DIM
Filter DIM
or BOTH
Bump Any setting
Master Fader Up (typically full on)
Manual Fader Up (typically full on)
Programmer Fader Up (typically full on)
2. Using the side wheel, display channels with numbers higher than 24 (LP-X24) or 48
(LP-X48).