Leprecon LP-X24 Manual v3.2 Addendum - Manual (Page 44)

Conventional Light Programming Chapter Three 43
LP-X24 and LP-X48 Users Manual
Button/Fader Setting
Modes Record and Scene
Display DIM
Filter
DIM or BOTH
Bump Any setting
Master Fader Up (typically full on)
Manual Fader Up (typically full on)
Programmer Fader Up (typically full on)
2. Raise the manual scene faders for the lights in the first look.
Start with the Bank button set to the first bank. Raise the faders for the lights you
want to include. Switch the Bank button to the second bank. Raise the faders for the
lights you want to include. Note: If you raised Manual Scene Fader 1, for example,
and now want to include the lights on Manual Scene Fader 13 (LP-X24) or 25 (LP-
X48), you will need to bring the fader down to the zero level and then raise it. This is
called match and grab.
The LP-X display shows you the manual scene faders and their levels.
All faders at zero:
Recording new scene
Select
Level
Fade
0:00
01 02 03 04 05 06 07 08 09 10 11 12
13 14 15 16 17 18 19 20 21 22 23 24
Manual Scene Fader 1 set to 50% and Manual Scene Fader 2 set to 100% (FF).