beautypg.com

Pppoe (dsl), Internet setup – D-Link DIR-825 User Manual

Page 24

background image

20

D-Lnk DIR-825 User Manual

Secton - Configuraton

Select

PPPoE.(Username/Password) from the drop-down menu.

Select

Static.IP if your ISP assigned you the IP address, subnet mask,

gateway, and DNS server addresses. In most cases, select

Dynamic.

Enter the IP address (Static PPPoE only).

Enter your PPPoE user name.

Enter your PPPoE password and then retype the password in the next
box.

Enter the ISP Service Name (optional).

Select either

Always-on, On-Demand, or Manual.

Enter a maximum idle time during which the Internet connection is
maintained during inactivity. To disable this feature, enable Auto-
reconnect.

Enter the Primary and Secondary DNS Server Addresses (Static PPPoE only).

Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1492 is the
default MTU.

The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless required by your ISP. You can use the

Clone.Your.PC’s.

MAC.Address button to replace the Internet port’s MAC address with the MAC address of your Ethernet card.

My Internet

Connection:

Address Mode:

IP Address:

User Name:

Password:

Service Name:

Reconnection Mode:

Maximum Idle

Time:

DNS Addresses:

MTU:

MAC Address:

Internet Setup

PPPoE (DSL)

Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide

you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE

software from your computer. The software is no longer needed and will not work through a router.