Dimplex Fireplace DFG3033 - Manual (Page 13)

13
Operation
Frequency Interference
If the fireplace does not respond
properly to the remote control,
the remote operating frequency
may have to be reset. The
remote control can send another
frequency code to the circuit
board to eliminate interference.
simultaneously press the 1.
“ Temperature Down” button
and the “ Flame Speed
Down” button on the remote
control (Figure 7).
“
2. COD” will appear in place of
the sleep timer digits.
Release the “
3. Temperature
Down” button and the “Flame
Speed Down” button.
Press the Initialization button
4.
on the unit (Figure 5C).
Press the Flame/heat on/
5.
off button button on the
remote.
Your remote will now
have a different frequency
communicating with the fireplace.
Remote Control Functions
(all letter references are to Figure 7)
B. Set Temperature
Press F button to turn fireplace
on.
Press
H to raise thermostat.
Press g to lower thermostat.
Press both H and g to change °F
to °C.
C. Dimmer
Press the F button to turn the
Flame/heat on.
Repeatedly press the
J or I button
to decrease or increase the
brightness of the upper lights.
D. Flame Speed
Press the F button to turn the
Flame/heat on.
Press the
L button to increase the
speed of the flame.
Press the
K to decrease the
speed of the flame.
E. Sleep Timer
The sleep Timer automatically
shuts off the fireplace after a
preset time (from 30 minutes to 8
hours).
Press the
F button to turn the
fireplace on.