Vertex Standard eVerge EVX-531 - Manual (Page 32)

EVX-530 S
EriES
O
pErating
M
anual
30
t
alK
a
round
(ta)
Press, (or press and hold), the assigned PF key to
activate the Talk Around feature when you are op-
erating on duplex channel systems (separate receive
and transmit frequencies, utilizing a “repeater” sta-
tion). The Talk Around feature allows you to bypass
the repeater station and talk directly to a station that
is nearby. This feature has no effect when you are
operating on “simplex” channels, where the receive
and transmit frequencies are already the same. In the
EVX-534/-539, when the Talk Around feature is ac-
tivated, the “ ” icon will be indicated on the display.
Note that your dealer may have mode provision for
“Talk Around” channels by programming “repeater”
and “Talk Around” frequencies on two adjacent chan-
nels. If so, the key may be used for one of the other
Pre-Programmed Functions.
Note: The Talk Around feature does not activate on
the Simplex Channel.
rEsEt
Press (or press and hold) the assigned PF key to reset
the RFC (Ready for Communication) condition.
c
all
1
to
c
all
3
(EVx-531)
c
all
1
to
c
all
5
(EVx-534 & EVx-539)
Press, (or press and hold), the assigned PF key to
send a pre-programmed call signal of the 2-Tone,
5-Tone, MDC1200
® or Digital Call.
c
odE
u
p
/d
oWn (EVx-534 & EVx-539)
Press, (or press and hold), the assigned PF key to
select a 2-Tone or 5-Tone encode code from the pre-
programmed encode list.
c
odE
s
Et (EVx-534 & EVx-539)
You can change the desired digit of the 5-Tone en-
code code using this function:

Press, (or press and hold), the assigned PF key.
 Enter the desired 5-Tone encode code directly
from the keypad ([0] - [9] key).
 Press the [D] key to store the new setting. The
display indicates “- SET -” briefly, then reverts to
the normal channel indication.
You may cancel the new setting by pressing
the [C] key. In this case, the display indicates
“- CANCEL -” briefly.
a
dVancEd
o
pEratIon