Vertex Standard eVerge EVX-531 - Manual (Page 29)

EVX-530 S
EriES
O
pErating
M
anual
27
(two digits) and channel number (three digits)
from the keypad ([0] - [9] key).
 Press the [D] key to call the new channel.
You may cancel the direct channel entry by press-
ing the [C] key. In this case, the display indicates
“- CANCEL -” briefly.
s
can
The Scanning feature is used to monitor multiple
channels programmed into the transceiver. While
scanning, the transceiver will check each channel for
the presence of a signal, and will stop on a channel
if a signal is present. EVX-530 series can scan both
digital and analog frequency programmed channels
simultaneously.
To activate scanning:

Press, (or press and hold), the assigned PF key to
activate scanning.
 The scanner will search the channels of each
channel, looking for active ones; it will pause
each time it finds a channel on which someone is
speaking.
 Press again, (or press and hold again), the as-
signed PF key to disable scanning, and receive
the channel which was chosen when pressed the
PF key.
Note: Your dealer may have programmed your radio
to stay on one of the following channels if you press
the PTT switch during scanning pause:
 “Scan Pause” channel (“Talk Back”)
 “Last Busy” channel
 “Priority-1” channel
 “Priority-2” channel
 “User Programmed” channel (“Select Channel”)
 The channel which defined in the CH Selector
knob.
g
roup
s
can
The scanning feature is used to monitor multiple
channels programmed into the transceiver. While
scanning, the transceiver will check each channel of
the programmed group for the presence of the signal,
and will stop on a channel if a signal is present.
Press, (or press and hold), the assigned PF key to ac-
tivate the scanning on the selected groups.
Press again, (or press and hold again), the assigned
PF key to disable the group scan mode, and receive
a
dVancEd
o
pEratIon