Kleenmaid LWG74 Revision 5 Installation - Manual (Page 8)

6 38910
High Standpipe Installation:
Place the adapter into the standpipe. Remove the
beaded tie-down strap from accessories bag and place
around standpipe and drain hose, approximately 30 cm
(12 inches) down from the top of pipe and tighten strap
to hold hose to standpipe. This will prevent the drain
hose from dislodging from drain receptacle during use.
Low Standpipe Installation:
No. 562P3 Siphon Break Kit is required for this type of
installation. This kit is available (as optional equipment
at extra cost) through an authorized dealer or parts
distributor. Installation instructions are supplied with
the kit.
W327IE1B
DRAIN
HOSE
TIE-DOWN
STRAP
STANDPIPE
(Standpipes higher than 122 cm [4 feet]
are not recommended)
STANDPIPE
ADAPTER
W416IE1A
562P3
SIPHON
BREAK
KIT
DRAIN
HOSE
STANDPIPE