Kleenmaid LWG74 Revision 5 Installation - Manual (Page 7)

Installing the Washer
38910 5
Step 4:
Connect Drain Hose to Drain Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by unhooking the hose from the
retainer clamp.
Find the instructions, on the following pages, that are
appropriate for your type of drain receptacle
(standpipe, high standpipe, low standpipe, sink, wall,
or laundry tub). Follow these instructions to properly
install the drain hose.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 32 cm (1-1/4 inch) outside
diameter drain hose.
Standpipe Installation:
Place the adapter into the standpipe.
Remove the beaded tie-down strap from accessories
bag and place around standpipe and drain hose,
approximately 30 cm (12 inches) down from the top of
pipe and tighten strap to hold hose to standpipe. This
will prevent the drain hose from dislodging from drain
receptacle during use.
IMPORTANT: To prevent siphoning, do not place
any ribbed portion of the drain hose into the
standpipe.
W324IE0A
RETAINER
CLAMP
STANDPIPE
ADAPTER
W325IE1C
DRAIN
HOSE
SLEEVE
30,489
cm
(12")
STANDPIPE
5,08 cm (2") or 4 cm (1-1/2")
DIAMETER
TIE-DOWN
STRAP
STANDPIPE
ADAPTER
RIBBED
PORTION OF
DRAIN HOSE
91,44 cm
(36")
Recommended
Height