Kleenmaid LWG74 Revision 5 Installation - Manual (Page 6)

Installing the Washer
4 38910
Step 3:
Connect Water Inlet Hoses
NOTE: Refer to Section on Water Supply
Requirements before connecting water inlet hoses.
Remove the two screened filter washers and the two
plain rubber washers from accessories bag, and install
them according to the illustration.
Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign
materials that could clog the filter screens in the inlet
hoses, or the screens in the water mixing valve.
NOTE: When installing in newly constructed or
renovated building, it is very important to flush the
lines since build-up may have occurred during
construction.
IMPORTANT: Thread hose couplings onto valve
connections finger-tight, then approximately 1/4
turn with pliers. DO NOT cross thread or
overtighten couplings.
Turn water on and check for leaks. If leaks are found,
retighten the hose couplings. Continue tightening and
rechecking until no leaks are found.
RUBBER WASHER
(Plain)
W004IE1G
FILTER WASHER
(Screen must be
facing outward)
INSTALL THIS
END OF HOSE
(WHITE COUPLING)
TO WATER
SUPPLY FAUCET
INSTALL THIS END OF HOSE
(BLUE COUPLING)
TO VALVE CONNECTIONS
AT REAR OF WASHER
INLET
HOSE