Kleenmaid LWG74 Revision 5 Installation - Manual (Page 11)

Installing the Washer
38910 9
Step 7:
Add Water to the Washer
To prevent damage to pump, do not run washer before
adding at least one quart water to the tub. If the washer
is run before any water is added, the pump seal may
overheat causing the pump to leak. Once installed, the
water retained in the drain system from the previous
cycle will provide sufficient cooling to prevent pump
seal damage.
NOTE: The agitator should not be removed except
for service. The washtub is designed to be self-
cleaning.
Step 8:
Check Lid Switch
Washer should stop spinning when lid is opened.
Step 9:
Check Installation
Refer to Installer Checklist on the back cover of this
manual and make sure that washer is installed
correctly.
W391IE1A
W376IE0C