Kleenmaid LWG74 Revision 5 Installation - Manual (Page 13)

38910 11
Water Supply Requirements
NOTE: Water supply faucets must fit standard 3/4 -14
BSP metric female couplings. DO NOT USE SLIP-ON
OR CLAMP-ON CONNECTIONS.
NOTE: Water supply faucets should be readily
accessible to permit turning them off when washer
is not being used.
Water Temperature
Cold:
Recommended cold water temperature is 10° to 24°
Celsius, 50° to 75° Fahrenheit.
Hot:
Recommended hot water temperature is 60° to 66°
Celsius, 140° to 150° Fahrenheit.
Warm:
Mixture of hot and cold water. (Warm water
temperature is dependent upon the water temperature
and the pressure of both the hot and cold water supply
lines.)
IMPORTANT: Turn off water supply faucets after
check-out and demonstration. Owner should turn
off water supply whenever there will be an extended
period of non-use.
NOTE: A longer inlet hose is available (as optional
equipment at extra cost) if the hose (supplied with
the washer) is not long enough for the installation.
Order hose as follows:
Part Number WA003 – 2,5 m Inlet Hose
Under certain conditions, hydrogen gas
may be produced in a hot water system that
has not been used for two weeks or more.
HYDROGEN GAS IS EXPLOSIVE. If the hot
water system has not been used for such a
period and before using the washer, turn on
all hot water faucets and let the water flow
from each for several minutes. This will
release any accumulated hydrogen gas.
The gas is flammable. Do not smoke or use
an open flame during this time.
W029
WARNING
C
H
W187IE1A
WATER INLET HOSES
COLD WATER
CONNECTION
HOT WATER
CONNECTION
WATER
SUPPLY
FAUCETS