Kleenmaid LWG74 Revision 5 Installation - Manual (Page 10)

Installing the Washer
8 38910
Step 5:
Position and Level the Washer
Place rubber feet on all four leveling legs.
Place washer in position on a clean, dry, and reasonably
firm floor. Installing the washer on any type of
carpeting is not recommended.
Loosen 7/8" locknuts and adjust the two front leveling
legs. Once adjusted, tilt the unit forward on front legs
and lower back down into position to set the rear self-
leveling legs.
Washer must not rock. After washer is at desired
height, tighten locknuts securely against bottom of
washer base. If these locknuts are not tight, washer will
not remain stationary during operation.
Improper installation or flexing of a weak floor will
cause excessive vibration.
Do not slide washer across floor once the leveling legs
have been extended, as legs and base could become
damaged.
Step 6:
Plug In the Washer
Refer to section on Electrical Requirements, and plug
the washer in.
LEVELING
LEG
W179IE1A
LOCKNUT
LEVEL
RUBBER
CUP
WASHER
BASE
W504SE3B