Troubleshooting guide, Important, Program clock display is flashing – Kleenmaid TO600X User Manual
Page 26: Signal lamp does not turn on, Fuses often burn out, Oven light is not on, Oven does not heat up, Baking results are disappointing
Instructions for use, installation and connection
26
Troubleshooting guide
Any unskilled attempt to repair the appliance is
extremely dangerous as it can cause electric
shock and short circuit. To avoid such injuries any
repairs must be performed by qualified personnel
only.
However, there are some minor faults which may
be easily removed by the user, in accordance with
the instructions that follow.
Important!
If the malfunction of the appliance was caused by
improper use, the service visit during the warranty
period is not free of charge.
Following are some simple suggestions on how to
repair minor faults:
Program clock indicates faulty
values or switches on and off
intermittently…
Switch the oven off, disconnect it from the mains
for a few minutes (unlock the fuse or switch off the
main switch), then reconnect it to the mains and
set the correct daily time.
Program clock display is flashing…
There may have been a power failure, or the oven
has been connected to the mains for the first time.
All settings are erased. Set the correct time of day
to be able to activate the oven. After operating in
automatic mode, the oven switches off, the display
indicates time, and the beep is heard. Take the
food from the oven, set the temperature selection
knob and the mode knob into their original
positions. Select the "Manual mode", and use the
oven in a conventional mode (without
programming).
Signal lamp does not turn on....
•
are all the required switches properly activated?
•
is the mains power fuse burned?
•
is the temperature regulator properly set?
Fuses often burn out...
•
Call the serviceman or your electrician!
Oven light is not on....
•
The replacement of oven bulb/s is described in
the section "Replacement of parts".
Oven does not heat up...
•
is the mains power fuse burned?
•
is the temperature regulator set correctly?
•
did you set the oven to the conventional mode
after using it in the automatic mode
(programmed)? Switch the mode button to the
position "Manual mode".
Baking results are disappointing...
•
did you remove the grease filter?
•
did you follow the instructions and warnings from
the section "Baking"?
•
did you strictly follow the information from the
baking table?