Kleenmaid TO600X - Manual (Page 12)

Instructions for use, installation and connection 12
The oven may be controlled in two ways
1 By selecting the type of food
2 By selecting the function mode
Switching between the two control
modes
•
The oven is off:
−
If mode (1) is selected, you may switch to
mode (2) by pressing the sensor (2) twice (if
oven selector is on illumination only, one touch
of the sensor is enough). All settings relevant
to mode 1 are erased.
−
Similarly you may switch from mode (2) to
mode (1) (in such cases touch sensor (1)
twice).
•
The oven is on:
−
Switching is not possible.
−
If you still wish to change the function mode,
first switch the oven off by touching the
ON/OFF sensor (5) (the signal lamp (5a) is
flashing) and then select the desired function
mode.
Food selection mode
This mode is appropriate for the preparation of the
chosen food with automatic setting of mode,
temperature and operation time.
•
Touch the food selection sensor and select the
type of food (appropriate symbol and relevant
function mode are lit, as well as the temperature
and operation time)
•
Touch the ON/OFF sensor (5) to start the
operation. After the expiry of the set time the
oven is switched off automatically.
•
In case of different quantity of food, you may still
use this mode, but you must change the
operation time and the temperature accordingly.
•
You may however use the end of operation
function (see »End of oven operation« section).
While the signal lamp (5a) is flashing, you
may change settings at random. If the oven is
not switched on in approximately 15 seconds
after the last touch of any sensor, it will switch
off automatically.
After the oven is switched on (signal lamp 5a
is lit) you may revoke the setting by
consequent touch of the ON/OFF sensor (5)
(signal lamp 5a is flashing) and the oven will
switch off automatically after approximately 5
seconds.