Kleenmaid TO600X - Manual (Page 25)

Instructions for use, installation and connection 25
Removing wire and telescopic guide
grids
Telescopic side racks or wire racks may be
removed to facilitate the cleaning of the oven. Side
racks are removed by swinging the bottom side
inwards and unhooking them.
Clean the side racks and telescopic guides only
with conventional detergents.
Telescopic racks must not be washed in a
dishwasher.
Note! Never lubricate the telescopic racks!
To reinsert, repeat the procedure backwards: slide
them into the holes and swing downwards.
Accessories
Accessories, like the biscuit tray, oven tray, etc.
are cleaned with hot water and the usual
detergent.
Special enamel
The oven, interior door lining, baking tray and
grease interception pan are coated with special
enamel, with smooth and resistant surface.
This special coating facilitates cleaning at room
temperature.
Grease filter
Clean the grease filter after each use with a soft
brush in hot water with some detergent, or wash it
in the dishwasher.
Removing oven door with a single
axe hinge
Open the door completely and turn the removable
locks backwards (see fig). Then close the door
slowly and let the locks fit to the notches. At an
angle of about 15
°
lift the door slightly up and pull
the door from the hinge supports (fig. 2).
For reinserting the door repeat the procedure
backwards. Insert the door at an angle of about 15
°
into the hinge supports by pushing them forward
and downwards, so the hinges lock into their slots
(fig. 3). Check if the hinges are locked into their
respective slots.
Now open the door completely and turn the
removable locks into their original position. Close
the door slowly and check if they close properly (fig.
4). If you have trouble closing the door, check if the
hinges are properly inserted into their slots.
Attention! Never let the hinge locks spring out, as
the springs are strong and may cause injuries.