Assemblage du système mig, Plaatsen van het mig systeem, Montage des mig-systems – Kemppi Promig 520R User Manual
Page 9: Assembly of mig system, Samling af mig system, Hvordan montere mig systemet, Sammanställning av mig-systemet, Mig-laitteiston koonta
PROMIG 520R, 120R / 0544 – 9
© KEMPPI OY
2.4. ASSEMBLY OF MIG SYSTEM
Assemble the units according to the mounting instructions delivered with the unit.
1. Installation of power source
Read paragraph “INSTALLATION” in operation instructions for PRO power sources and install
accordingly.
2. Mounting of PRO power source to transport wagon
P 20 see air-cooled MIG system
P 30W see liquid-cooled MIG system
P 40 see air-cooled MIG system
3. Put PROMIG onto the power source and lock it with bolts to handles of power
source.
4. Mounting of PROMIG control panel
MC 6263501
see mounting instructions 4270950
ML 6263502
see mounting instructions 4270950
MXE 6263504
see mounting instructions 4279220
5. Connecting cables
Connect cables according to paragraph ”UNITS, ACCESSORIES, CABLES”.
6. Max. wire feed speed
By delivery, the max. wire feed speed is 18 m/min, which is enough for most welding applications.
If you need a higher speed, you can increase the wire feed speed to 25 m/min by replacing the gear
wheel on motor shaft. The high ratio wheel (*D40*) is delivered with the feed unit.
Changing the maximum wire feed speed:
– Open side plate and remove JUMPER 3 on control card A001. This alters the tacho feedback
ratio to 0 - 25 m/min.